Technobeam Overheats after 10 min

motor city pro audiomotor city pro audio Registered User
edited November 2012 in HES Automated Lighting
I have a technobeam that will shut down after 10 min with a over heat err. Any ideas?

Comments

  • tadawsontadawson Registered User
    edited November 2012
    I'd start with the obvious - are the fans running?

    If they are, and seem to be moving good air, then I'd check the temp sensors . . .

    - Tim
  • BigFireBigFire Registered User
    I'm getting an Over Temp on one of my units as soon as it boots up and completes the homing process. Fans are working, in fact it is running at high speed. I've re-seated all of the sensor connectors on the logic board, but noticed those are all for systems control like gobos, pan, tilt, etc. Where are the Temp Sensors located so I can check those specifically? Thanks!
  • ChrisLitzChrisLitz Registered User, HES Staff
    The temp sensor is actually on the logic board located at U2. I would swap the logic board between the faulty fixture and a good fixture to be 100% sure that the issue is withing the logic board. If it is determined that the logic board is indeed the problem then contact Light Parts to have it repaired.
Sign In or Register to comment.