IPCB Fader Bug 3.2.5

rolfwenzelrolfwenzel Registered User, Hog Beta
Setup:
Hog3PC
3 x Playback Wing
1 x Programming Wing
1 x Super Widget
SW Version 3.2.5

It is a kinda funny bug:

Show is programmed, on one fader I got a Circle FX without Position Information as a Cuelist (only one Cue) as IPCB Fader.
Position Information comes from Pallet "MAIN" and is stored in another cuelist and got Persist on override activated

I now got this Circle FX pushed in to 30% (for Spots only) and see the Spots moving very slowly.

At the same time I'm trying to correct the position of the washes a bit and merge the new Position information into Pallet MAIN (the same pallet as for the Spots)

In that moment when I hit enter the Circle FX with the Spots on the IPCB Fader goes to FULL.

This was reproducable....

Best

Rolf

Comments

  • spiritbransonspiritbranson Registered User
    edited September 2012
    Yes, it will also exhibit the same behavior if you update ANY pallette while running an effect in an IPCB fader.
  • PimmerPacKPimmerPacK Registered User
    edited October 2012
    Yes, I have run into the same problem last weekend.

    Updating palletes using the following comment:
    "Color 1 Copy to Color 2, more, replace, Enter"

    I was working on a Hog III with Exp.Wing & DP8000.
  • ChuckhicksChuckhicks Registered User
    edited June 2014
    I am experiencing an issue with down fading after pressing go or flash. I pull the fader down slowly and no fade but go's straight to off at 0.
Sign In or Register to comment.