Keeping a moving head from hitting a TV?

K i have some elation platinum beam 5R's basically sharpy knockoffs but none the less A HIGH OUTPUT BEAM that can burn thing within 4 feet of them and i have a tv screen next to where they are hangin (NO I CANT MOVE THE TV OR PLAT BEAM ) how do i program the light to where defaults wont let it hit the tv when in an effect ?
:aargh4::dunno:

0 Former HES Forums Member over 11 years ago

Edit Fixtures (Section 14.3.2 of the manual) can set Min and Max values for pan and tilt. This may let you do what you're looking for.

Setting limits can be good for keeping your light beams off of unsightly positions, but, you should not reply on it for safety. If your fixture is close enough to burn something you need to take other precautions
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 djkermie - Former HES Forum Member over 11 years ago

THAT DID IT THANK YOU PS it would not burn it I just wanted it off the tv comletely and that did the job thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 djkermie - Former HES Forum Member over 11 years ago

k i need to do this again in hog 4 , whats the page in that manual plz thank you
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marc lorenz over 11 years ago

it´s 5.7.2 for Hog4 Manual
But the functions are the same as in HOG3. Also in the same place to find as HOG3
Means same buttons presses etc....
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel