Multiple fixture libraries

I need to use fixture profiles form both the uncommon and regular fixture library....is there anyway to merge the two or use both in the same show? I just need a way to make this work. I'm trying to use the Martin Roboscan 918, MAC 250 entour, and generic RGB LED profiles.

0 kurtiswilk - Former HES Forum Member over 11 years ago

You need to merge the two together.

Start your show with the regular library. Then do:

Setup > Shows > Merge

Pick your console from the drop down and then select the library you want to merge.
Select your fixture and then your set.

Sorry if its not exact. don't have the console in front of me.

Kurtis
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 joshrogers117 - Former HES Forum Member over 11 years ago

Thanks so much!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marty postma - Former HES Forum Member over 11 years ago

A word of caution here....

DO NOT MERGE THE ENTIRE LIBRARY. Just Merge the fixtures you need from Uncommon.

Otherwise you will likely run into some rather severe problems when you hit the limit of fixtures you can merge into a show.

Hope this helps. :)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel