Lighting Console Cart

Playdoe9Playdoe9 Registered User
edited December 2011 in Misc. Discussion
Hey Community.

I am about to buy/make a lighting console cart for my Whole Hog 3 PC setup. Just wondering what you guys have done and if you could graciously post any photos. I am thinking a customized magliner with a middle shelving or building from scratch.

http://www.filmtools.com/filmtools-patron-senior-cart.html

Thanks

-Ben

Comments

  • cormacjackcormacjack Registered User, DL Beta
    edited November 2011
    Hi,
    What about something standard off the shelf like this?
    http://images.peliproducts.co.uk/3dcases/1630/1630.html

    Get a custom divider or mould cutout made.Peli cases are very hardwearing,waterproof and you can add a lock if required.

    Best C
  • leebotleebot Registered User
    edited November 2011
    Actually a pelican 1650 will allow you to keep the wings in the same foam that they shipped from the factory in side by side by side with room on top for a laptop and extra monitor or touchscreen.
  • Playdoe9Playdoe9 Registered User
    edited November 2011
    I am looking for more of a solution for using the console, instead of just a table. Not so much for transporting. But a cart, that I can take with my console to set.
  • MitchMitch Registered User, HES Staff
    edited December 2011
    One thing about the cart above, if you programming for long periods it may be uncomfortable as you cannot put your legs under the table with the lower shelf in place.
Sign In or Register to comment.