Rhfb problem. Help yet again.

Dear people with answers.
I have a road hog full boar. Worked perfect yesterday. Today startup went smooth. Now everything is delayed 3 seconds. Pan, tilt, clear, grand master, to pig release. Everything I do takes 3 seconds to respond.
I have reinstalled 3.1.7. No luck.
Also light at full. 4 seconds light comes On then about 8 seconds later the output window responds.
I have restarted the console 2 times.
What can I do to make it work?

Thanks yet again.

0 sfeerpeer - Former HES Forum Member over 13 years ago

Any USB-devices connected? Then try to unplug and see what happens.

Or try to load another other show, maybe your showfile is corrupted.

Else a complete restore with new XPe? (remember to backup all your showfile first!)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 snowmaniac153 - Former HES Forum Member over 13 years ago

No USB was plugged in. Loaded a blank show an had the same problem.
It is a rental. So I just made far less looks then normal and I will just wash my hands of it in 3 more days.
Some people I work with say one of the ram board to a dump. Would this make this problem?
I'm glade 4 sec responds is not normal. That would be a horrible way to run a show.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mitch - Former HES Forum Member over 13 years ago

We had a similar report the other day and the Fixture Net (Artnet) settings were causing an issue. Once we selected BROADCAST on each of the Artnet outputs the delay went away.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 snowmaniac153 - Former HES Forum Member over 13 years ago

I just went and looked at the artnet settings and everything is already broadcasting and all 4 universes are checked. No luck there.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 preworks - Former HES Forum Member over 13 years ago

Hi Snomaniac 153

We had this issue once in a show. It was a problem with the network setup.

Try "use default IP adress" and boot server only.

I our situation was this the solution..

BR
Andreas
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 snowmaniac153 - Former HES Forum Member over 13 years ago

Preworks. Your my hero. Thanks so much. That was it. Thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 preworks - Former HES Forum Member over 13 years ago

Perfect!

Austria is not only a paradise for skiing;-)

Cheers,
Andreas
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel