"at full" not working

ChanneldaveChanneldave Registered User
Hey all,
I'm doing a show on a Hog1k. and for some reason I can't get any fixtures to respond to "@ full" or "@ anything" for that matter.
Even the desk channels will not respond. but if I go to the intensity wheel and use that I can adjust intensity.

any ideas?

Comments

  • tadawsontadawson Registered User
    edited November 2010
    Do you see the "@" character on the command line? Any chance the key is bad?

    - Tim
  • ChanneldaveChanneldave Registered User
    edited November 2010
    yes I see "at" in the command line. I also used the EV monitor and all the keys are working
  • quinnquinn Registered User
    edited November 2010
    I can't get any fixtures to respond to "@ full" or "@ anything"
    see [POST=41349]this post[/POST].
  • ChanneldaveChanneldave Registered User
    edited November 2010
    interesting, I don't have "kind =i" in the lib file. I pasted the text below:


    parameter = Intensity
    default = 0
    highlight = 255
    crossfade = 0
    type = ltp8bit
    range = 0, 255, %

    parameter = Intensity
    default = 0
    highlight = 100
    crossfade = 0
    type = htp8bit
    range = 0, 255, %
  • quinnquinn Registered User
    edited November 2010
    does your FUNCTION.TXT have Intensity = + ?
  • ChanneldaveChanneldave Registered User
    edited November 2010
    the function.txt has "intensity = i"

    should it have "+"?
  • ChanneldaveChanneldave Registered User
    edited November 2010
    ok, I just changed it to "+" and it works. Thanks! I was thinking that that other post you directed me to was talking about the Lib lib file.


    THank you!

    is it bad to change this kind of stuff in an exixting show?
  • stannystanny Registered User
    edited June 2011
    hello guys,

    I have the same problem. I checked the function.txt file and intensity = +

    Any idea what else could be the problem? I also checked the EV monitor, knobs are working perfect...

    regards
    stijn
  • MitchMitch Registered User, HES Alumni
    edited June 2011
    Some fixtures have two functions sharing one channel, for example 0-50% may be intinsity and 51-100% being strobe. The @ function doesn't usually work with these fixtures. This is just one possibility.
  • stannystanny Registered User
    edited June 2011
    it can't be the problem, even a deskchannel is not working at full...

    I really don't understand what is going wrong...
    Could a software update (has allready the latest version that was build) help?

    Stijn
  • MitchMitch Registered User, HES Alumni
    edited June 2011
    If you have checked the EVENT MONITOR and all buttons are working ok, I will recommend a CLEAN START on the console. This will erase the show from memory and you will need to reload it from disc so make sure you have a good backup.

    If that doesn't help I would start a new show as a test and see if it has the same problems to isolate the problem to the software/console or the show file you are currently using.
Sign In or Register to comment.