575 CMY CLR1 Err

i have a 575 CMY that is giving me the "CLR1 Err". Where do i start? I have read that it may just be a dirty sensor but am unsure of where that is to clean..

I do realize that it could be a bigger problem than just a little dirt but if a quick spot cleaning is all it takes I'd be really happy!

Any help would be great.

0 puffyfish - Former HES Forum Member over 13 years ago

If you do have to replace the motor do it in a well lit area and lay out a towel for the parts. Pay special attention to the nylon washers!
Get some Krytox to re lube the wheels and see this post for some tips.
forums.highend.com/showthread.php?t=9689
Where the top lock ring is set on the shaft is paramount to making it all work again. Be very careful.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel