Automated Lighting

HES Automated Lighting Changing fixture address

State Not Answered
Date stevejarden
Date Fri, Jun 8 2012 12:15 PM
Replies 3 replies
Subscribers 11 subscribers
Views 388 views
Users 0 members are here

Changing fixture address

Im trying to change the address of some EC-2's Using Echo but does not seem to working. is this not possible? i thought it was.

Cheers

Steve

0 Former HES Forums Member over 11 years ago

Echo can only set the DMX address of newer fixtures that support RDM.

To address an EC-2, you'll need a Handshake system or a Wholehog 2 running the version 4 beta software.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 stevejarden over 11 years ago

Thanks for that. are there any plans to do this with Echo or hog 3 as the handshake is a little pain full
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former HES Forums Member over 11 years ago

EC-2 has not been under active development for quite a while, so it's unlikely to see any new software features.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Related